Hello all. I was trying to connect some wiring on my 68 Firebird and came across some connectors on the harness leading to the rear lights. These connectors are at the end close to the fuse box. I found two wires that looked like they connect to the door jamb switch on the drivers side (I connected them). See photo below.
I also cam across a connector right next to the "door jamb switch" wiring that does not seem to go anywhere. It has orange and white wires that I think means that it is for courtesy lights, but not sure . Below are photos of this connector. If this is for courtesy lights, what harness should I purchase and will it have the same type connector?
Another question is where am I supposed to connect the high/low beam switch wiring. I installed a new switch but the end of the wires are bare and I am nut sure where to go with them.
2012 Mustang Boss 302 #1918, Competition Orange. FGF replacement 2006 Mustang V6 Pony, Vista Blue. Factory ordered. 2019 BMW X3 (Titled to the wife, but I'm always driving it for her. So I'm claiming it) Old projects, gone but not forgotten: 1967 FB 400, original CA car. After 22 years of work, trashed by the guy who was supposed to paint it. I had to sell it. 1980 Turbo Trans Am 1970 Mustang fastback, 351C 4Bbl, auto 1988 Mustang GT, 5 speed 1983 F-150 4x4, built 302 1994 Chevy K2500 HD 4x4, 454 TBI
The dimmer switch should have three wires to it, high, low and power from the switch, green tan and blue. Should be able to buy the pigtail plug for that and the courtesy light socket from napa.