Does anyone have information on how the rally gauge wiring is set up for the volt gauge? All other wires are fine, but some idiot cut the black and white wires coming from the back of the cluster and I can't find a wiring diagram that shows where these two wires terminate. I plan to buy a new under-dash harness, but need to know if this is part of that harness (again, can't tell from what is left). I even pulled all the elec tape off the existing harness and could not find the white and black wires anywhere. A previous post (very good article) talks about getting the proper feeds from the power junction block (at the regulator) and the battery distribution connector (near the battery). Once again, I can't find any wiring that used to be in those locations. I think that those same 'feeds' are available elsewhere under the hood, but I'm not sure? Any help with this?
The horn relay and the green wire going in to the regulator are where I finally connected mine due to no wiring diagram, works fine and don't have to run the wires across the rad support..