Can anyone tell me if the column connectors in the image below are correct for the 69 column? I'm thinking they're not based on the original 69 steering column I just picked up from Speer Classic.
The blue connector don't match the column connectors.
If it is incorrect, does anyone know where I might find the correct connector? I can pin out the wires easy enough.
Here's a diagram of the '69 column harnesses, one section for turn signal switch, hazards, horn, key buzzer which is a long flat connector, and the second for ignition.
Definately the ignition switch connectors. Does anyone sell or make the plastic connector housings?
I used your picture for reference points to narrow things down. The under dash harness was butchered pretty badly. Had to reconstruct, solder and heat shrink.
Eventually, but not right now. I'm simply trying to get the car to pass state inspection so I have a driveable project.