I have a ´68 Firebird 400 with a manual disc/drum brake setup; the disc brakes are the original 4-piston calipers.
I'm looking to add a power booster, change the front disc to single piston calipers and replace all the rear drum brake pieces since I'm not sure if disc on the rear would add much to the braking power.
I was wondering is it better to go with a '69 front disc setup or get a 14' front disc kit? Also, since I'm adding a power booster, which lines do I need to order to accommodate the booster position?
This vehicle will not be used for drag/street racing but will be used on highways and winding country roads.
I bought the SS Brakes kit that fits stock spindles, and their SS brake lines which fit perfectly, I got the booster and new master cylinder from Ames and I bought the tuned stock distribution block from Classic Industries which is pre set for f disc r drum and tuned and fits the stock lines perfectly and looks stock.
The hardware from Inline Tube for the '69 front discs is less than Ames so I will call them on Monday. And since I'm buying the brake lines from Inline Tube as well, it will be easier to get everything from the same vendor.
Bartbird, where did you buy the SS Brake kit from?
I just installed Inline Tube's kit on my 67, I really like it. Note, the one I ordered had the new style all in one proportioning valve which does look different from the original factory setup including how the brake lines route. I also had to grind off a small amount on the bracket to make it not rub my JC Rally wheels (sounds worse than it is). Other than that it was a very simple install.
SS lines are stiff and harder to work with than steel. I did a SS fuel line and regretted it. Now I always use the stock type steel. For a car that is going to have limited exposure to the elements steel is fine. I think they tin plate the steel lines so they are somewhat corrosion resistant.
I am running 14" JC Rally wheels. They are tight, but there are no rubs. I ordered kit DBK6927 but then added a new set of brake lines and the electrical connector for the brake failure indicator. I ordered standard steel lines for the very reason you cited with respect to straightening the shipping bends. I figured the original set lasted 50 years, the replacement ones will get me to 100 years or my death, whatever comes first.
Update: I ordered a new upper booster kit (power booster, master cylinder and combination valve), the 9pc hard brake line kit and the brake conversion lines for from Inline Tube and '69 brake calipers and pads from Ames (Inline Tube was out of stock). Like I said above, the upper booster kit came with the combination valve instead of the proportioning and distribution valves.