Has anyone T’d their PCV into their power brake vacuum connection?
Long story, but I had to remove the 1/2” carb spacer to which I added a vacuum port for the PCV valve. The only other available port on my Performer RPM intake is at the #7 cylinder port. I’m afraid this will kill that cylinder.
Was thinking I may T the PCV into the same vacuum port, at rear of the carb, as the power brakes.
NOTE: I get only 11” of vacuum with my cam.
I'm a hobbyist. Not a professional...but I AM an F'n Premium Member. Don't be hatin'!
I tried something like that a long time ago on my 1st car. I'll bet you that you will end up with no power assist for the brakes like I did.
1967 FB 400, original CA car (smog), now 455, soon to be out of Paint Jail 2006 Mustang V6 Pony, factory ordered, retirement cruiser and future classic(?) 2019 BMW X3 (Titled to the wife, but I'm always driving it for her. So I'm claiming it) Old projects, gone but not forgotten: 1980 Turbo Trans Am 1970 Mustang fastback, 351C 4Bbl, auto 1988 Mustang GT, 5 speed 1983 F-150 4x4, built 302 1994 Chevy K2500 HD 4x4, 454 TBI
I think I'd be more inclined to use the no7 port for the brakes and the one on the base for the pcv. I've run the pcv into the 7 port before without issue but it's reall going to depend on how much oil goes through your pcv.