Hello, I'm having a lot of trouble with my pedal and would like to compare my setup with someone else. I have a 68 400 all stock and I would like to compare in particular someone's accelerator pedal connection to the throttle cable at the firewall. Mine seems to be off, the point of connection is higher than where the throttle cable comes through the firewall reducing some of my pedal travel. I am only able to obtain my idle speed at about 500rpm in drive or full throttle but not both at the same time. At 500 rpm my throttle cable is extremely taut against the inside of the firewall and my pedal hits the ground before I can reach full throttle. on the other hand, adjusting my setup to reach full throttle...I can't achieve 500rpms in drive. I can only get as low as about 900rpms. Also at full throttle in this scenario, the bottom of the accelerator pedal is a good 2 inches from the ground. Any help would be appreciated, I know it's hard to explain my problem. Any pictures of your stock 68 throttle setup would be great thanks!