Frequently Asked Questions

Find answers to Frequently Asked Questions for First Generation Firebirds that have been asked and answered on FGF. Special thanks needs to be given to all the FGF members who took the time to respond to other member's questions.

← Frequently Asked Questions

Dealer Technical Bulletins - Section 11 - Chassis Sheet Metal

Bulletin 68-T-11 — Pontiac Motor Division Dealer Technical Bulletin, Section 2, dated January 4, 1968. Attention: Service Manager.

Subject: Loose Front Seat Belt Inner Anchor Plate Cover — 1968 Pontiac and Tempest.

Short answer: If the front seat belt inner anchor plate cover is loose, first try engaging it under the existing bolt head; if there is not enough clearance, replace the anchor bolt with Part No. 7765672 and torque it to 25–45 ft-lb before re-securing the cover.

  1. Check whether there is sufficient clearance to engage the slot in the cover under the bolt head. If so, install the cover by securely engaging the slot under the bolt head.
  2. If there is insufficient clearance under the bolt head to secure the cover, remove the anchor bolt and install a new anchor bolt, Part No. 7765672 [MF] (Gp. No. 14.875).
  3. Torque the new bolt to 25 to 45 foot-pounds and secure the cover over the bolt head.
This is a transcription of the original dealer bulletin for easier reading and search. The complete original scan is shown below.

Content last modified: June 13, 2026 at 10:06 am

View Full FAQ

0 Comments - Leave a Comment

Bulletin 68-T-15 — Pontiac Motor Division Dealer Technical Bulletin, Section 11, dated March 11, 1968. Attention: Service Manager.

Subject: Appearance of Hood to Bumper Opening — 1968 Non-Air Conditioned Tempest.

Short answer: On a customer complaint basis only, improve the hood-to-bumper opening appearance on non-air-conditioned Tempests built before the breakpoints below by installing the filler panel now used on all Tempests except the GTO with Endura bumper. There is no charge to the owner.

Install Part No. 9793950 [M-3] (Gp. No. 8.155) — the filler used on all Tempests except GTO with Endura bumper. This repair applies on a customer complaint basis only at no charge to the owner.

The filler was installed on all Tempests built after the following breakpoints:

Production Breakpoints — Hood-to-Bumper Filler
VIN / Plant Code VIN / Plant Code VIN / Plant Code
B102511 P117681 Z103374
B600357 P601294 Z600200
K102068 G104352
K600185 G601378

Flat-Rate Information

Time Allowance
Operation No. Time Allowance Trouble Code
115-223-00 .2 hr. 29
This is a transcription of the original dealer bulletin for easier reading and search. The complete original scan is shown below.

Content last modified: June 13, 2026 at 10:06 am

View Full FAQ

0 Comments - Leave a Comment

← Frequently Asked Questions

Content last modified: June 9, 2026 at 7:10 am