Dealer Technical Bulletin 68-T-11 – Loose Front Seat Belt Inner Anchor Plate Cover – 1968 Pontiac and Tempest
Bulletin 68-T-11 — Pontiac Motor Division Dealer Technical Bulletin, Section 2, dated January 4, 1968. Attention: Service Manager.
Subject: Loose Front Seat Belt Inner Anchor Plate Cover — 1968 Pontiac and Tempest.
Short answer: If the front seat belt inner anchor plate cover is loose, first try engaging it under the existing bolt head; if there is not enough clearance, replace the anchor bolt with Part No. 7765672 and torque it to 25–45 ft-lb before re-securing the cover.
- Check whether there is sufficient clearance to engage the slot in the cover under the bolt head. If so, install the cover by securely engaging the slot under the bolt head.
- If there is insufficient clearance under the bolt head to secure the cover, remove the anchor bolt and install a new anchor bolt, Part No. 7765672 [MF] (Gp. No. 14.875).
- Torque the new bolt to 25 to 45 foot-pounds and secure the cover over the bolt head.
This is a transcription of the original dealer bulletin for easier reading and search. The complete original scan is shown below.
Content last modified: June 13, 2026 at 10:06 am
← Frequently Asked Questions
