Today was the day the rear diff went back together. Here's some info that may be of assistance for anyone wanting to do the same. I reused my original ring and pinion as they were in as new condition.
Timken Bearings
Inner Pinion bearing HM89449 Race HM89410
Front Pinion bearing M86649 Race M86610
Carrier bearing (x2) LM501349 Race (x2) LM501314
NAPA Pinion seal 19273
C/R Axle Seal 13492
GM crush sleeve 9785792
2.5 pints 80/90 oil
Machinist blueing for tooth pattern test
Pinion preload 15-25 in lbs. Had to use a breaker bar with 4 ft extension to initially collapse the crush sleeve to set pinion preload. Ended up with 18 in lbs.
Backlash .005 - .009 (check 4 different places and maintain no more than .002 difference)Ended up with .005 - .007
Bearing caps torque 70 lb ft
Had to shim .041 on one side and .047 on the other of the carrier for correct tooth pattern.
I choose to reuse the outer axle bearings but replaced the seals. The bearings felt good still and its an easy change later if needed.
Total time for rebuild (which included removing the old bearings and pressing on the new) was about 3 hours with the housing on the bench.
Total cost (not including oil, blueing or free use of a machine shop) $138.00 + 14.5% taxes = $160.00 well spent.
Now I just have to put the rear end back in the car and wait a few months till I finish the rest of the car to see if it howls.
Next step is to clean and paint the motor and trans. Doing the ST300 to Turbo 350 conversion.
Kind of ahead of myself but - Anyone know if the original driveshaft will fit?
I have a choice of 2 that I have in the shop. One from the ST300 and the other from a 4 speed.
