Makes sense. Thanks! At least it didn't come off of a mustang or something! I don't remember now but one side still had factory rivets on the ball joint and one side didn't. Also this side is a Lot harder to get installed so maybe the original got tweaked a bit in the mounts. I'll just mount it and then drill holes in the right place. Also I noticed on the drivers side the mount overhangs the a arm a little. It only can mount one way since the two holes are different sizes, but if one were to make the little hole a little bigger than you could flip the bumper around and it would look better while still contacting the frame correctly.
Anyways, thanks again.