Well where to start.

I put in the new Gold Plated regulator from Classic Industries, the results we the same.

Dim Glowing Gen Light!

I removed the plastic harness tape to the 12volt splice to give it a visual and it look factory fresh with solder and crimp. No problem with this crimp.

Dim Glowing Gen Light!

I replaced

1. Alternator.
2. Gold Plated Regulator from Classics.
3. Circuit membrane on Speedo cluster.
4. Cap to regulator.
5. Connector to Alternator.
6. Ignition switch.

I guess what’s left is the light bulb, and regulator connector. I will find the proper bulb with the right filament.

As I sit here and think about it (which is dangerous) I am going to pull all the fuses and see if that has any affect on the outcome.

The only item left on the bucket list is the orange Thermo HW wire on pin 3 of the regulator. Upon inspecting the splice I noticed that the wire is pretty ratty.

Has anyone dealt with this wire before?

Bob...