Well, I finally went over to my fathers house where I have been keeping an engine for about 6 years now. It was the engine that came in my bird when I first bought it. It was an original 326HO car, but unfortunately that engine is long gone. I knew practically nothing about Pontiacs at that time. So, here is what I found:

Engine - 350 YR code, year ?

Intake - 496140

Heads - 46, with 6H stamped on rectangular boss

I'm not sure the potential of these heads, but here is the story: When the engine was pulled, the heads were removed also. They were milled somewhere between .025-.035 (Don't exactly remember) They have the valve seats cut for 2.11/1.77 valves with hardened seats and three angle valve job. They also have been slightly ported and polished, mainly on the exhaust side. New brass valve guides too. Are these worth hanging on to? (I have the 4X, 4H heads on my 400 right now) Sorry this is so long. Please give any input on this stuff. Thanks.