I'm wondering if anyone has run into the same issues I'm having. I have Doug's (Pertronix) headers on the engine and have a MagnaFlow system ready to be installed. There seems to be 2 problems I'm having.
First, the MagnaFlow extension pipes out of the X-pipe, where they meets the headers... with them parallel to the ground/car body they are, centre-to-centre ~2" narrower than the headers.
Second, the extension pipes from the x-pipe to the headers need to dip below the crossmember, by roughly an inch to clear it, and then raise up again to meet the headers.
I'm going to have to get a new pair of pipes made, just wondering if anyone else has experienced this? I though it was going to be nice easy install. Ah well, nothing else has been thus far so I should've know better
