On the tail pipes, the right pipe contacts the frame forward of the axle.
(Pic #6)
The left pipe misses the rear hanger completely.
(Pic #7)
If I attempt to move or rotate either pipe to clear the frame or get closer to the hanger, each pipe moves completely out of its exit position.
Here are two shots showing how different the tail pipes are. At this position, both pipes are exiting the car as they should in between springs and quarter panels.
(Pics #8 and #9)
I’ve tried every possible move I can think of to make this work but have had no luck.
Please advise.
Larry DuBois
So, I am asking you guys, am I asking too much here for a better fit? They said they use original GM patterns, but if a human is bending the pipe, then the fitment quality is at the mercy of their skill.
