Doug & Dustin - I have seen that switch and bracket and I even contacted them about it. I asked if they had the cables to run from that switch to the trans solenoid or if they knew what I should use. They basically told me that they did not have anything that could be used. I also asked if there were instructions so I can see how it should all be setup. Again nothing. From the picture alone I can not see how the "switch" is operated. Where does it connect? Do I just run a regular electric line down to the tranny? Do I just run a power line to power it? These are the reasons I was looking at the Lokar setup. However if you or anyone else can walk me through it all I will gladly proceed with that setup instead.