Here it is when I was laying it out. At a glance it looks obvious but there are some corners in the front around the scoop posts holes that I'm not sure how/if it should follow. A pic like this of the foam installed properly would probably tell it all.
Just curious - did you find that you absolutely HAD to trim the underside of the hood for the upper pan to fit?
Yes, otherwise the hood frame interferes with the foam not allowing for a good seal. Here are a couple pictures
Also posted a few more in the "stuff" album: http://s262.photobucket.com/albums/ii106/colorado68/stuff/ Note.. I did have to cut a little foam by the passenger side scoop so it had a clean look from the outside. You also want to make sure you leave room to access the hood emblem nuts. Hope this helps.
