The front of the car sits level, but the right rear is higher than the left. I was thinking that it was the leafs. I just put new shocks in all around so I know that isnt the problem. I will check the spacing as jusride said, but if I want to check the height (front and rear), where are good spots to measure from? I would imagine that measuring from the wheel wells wouldnt be good because the sheetmetal may be off. A stupid question, I was looking at the sheet that jusride sent me and it shows where the lift points are, I have been jacking the car up and placing the jackstands under the subframe. The spot I have been using is that cross-member just in front of the motor. Is this bad or is this spot sturdy enough to jack from? Could it have caused this problem?
