I hope I'm not asking a question that's been covered over and over. I tried searching these forums and the internet, but couldn't find any answer.

I have a new Edlebrock carb with electric choke that I am installing. Old carb was a 2bbl with a mechanical stove-type choke. I need to find a power source that is only active when the key is in the run position. The coil only gets like 8v from it's resistor wire, so I don't think I can use that. Where should I pull this power from?

In the fuse block, there's a spot for "ign", but the terminal is missing. I've seen pics where there is a male spade terminal there, and that would be a perfect place to pull the power from...but there's no terminal on my fusebox.

I can find lots of sources with the key in the accessory position, but I think I'd rather have power in only the run position. I don't sit in the car a lot with the radio on...but if I did I'd rather not run the choke.

Anyone have any ideas? Again, sorry if this has been covered extensively...I really did try to look.