Good morning Liam I've been working on the issue, I changed out my Edeljunk 1405 for a Carter AFB 9635SA, rebuilt her, soaked it good in Chem dry, Blew every hole I could find out with Air! I also found out that on these carb's the needle has a clip that's suppose to be installed to tie the needle to the float I never installed it, the instructions do not show it anywhere. well test drove it yesterday and she performed very well, acceleration was right on the money, lots of power, idle a little rough with a slight miss. The temp is up around the 190's to 200's. seems much much better. Still working on the fuel issue, I installed a fuel filter before right before the pump, and I'm gonna test the flow from the pump, by disconnecting the carb line and cranking for 15 seconds, I should have about a pint or more of gas in a bottle. About 2 weeks or more ago she wouldn't go down the street without fouling the plugs, I needed to clean the carb, it was still dirty. This week will be the tester as I plan to drive it most of the week.
