I need to check my typing better. Yes the floor boards are bad under seats, center humped area and trunk look ok. The body, I saved about 70% of the front end, doors good ( minor patching) close nice and smooth with equal spacing, rear panels are bad from about a inch above the raised line in the panel down, across the trunk all usable. Some pitting on the frame but all bolt holes appear to be good. I looked at the rockers and did some rust removal they are solid and I took a hammer and tapped on the frame rails all the way back they are solid. Where the leafs attached is also solid. The car was parked in a garage in 80 and given to me a couple years ago. I spent a little time on engine to see if it still would run and it does it has 33k for mileage. People much more familiar with than me say it is not to bad. It appears I could lift the body straight up if I have the correct points which looks like where rockers attach and firewall area? Any suggestions would be much appreciated