So OHC are you saying $45 plus shipping is too much $$$ for a bolt-on solution?
As for the raw material if you really want to spend hours doing the measure/cut/grind/drill/paint your own in an effort to save another $25, just go to any local welding supply/steel store and buy some channel steel in the gauge/width you want. Then you can start from scratch and make your own.
Bill wants $100 plus shipping for the 4" set back. Big men must pay more for a low production part that isn't advertised .. Craze.
Yes. I like DIY project especially when it allows me to drive my Firebird.
