I have new everything. I clamped off all the soft lines, and I have a hard pedal. released the rear line, pedal still good. I reclamped it. I released the pass. side front , pedal drops. after a pump are two it firms up, but I can turn the tire by hand until, the pedal is pumped a few more times. when I release the driver side line pedal drops some but recovers after a pump. the brakes while I drive it will never grab hard. even at 2 mph with repeated brake applications and a firm pedal. I have done many bleedings , third master cyl., bench bleed all. the last one using both methods( with tubes and pluged). I have a hard pedal with line pinched, checked for bleed by on master. booster passes all test I have found. holds vacuum 10 to 15 mins after shut-off. could the round metering valve be bad? is there a way to test it? it's new but that means sh?t.
any ideas would be helpful. next step is do it all over again. or do a way with round metering valve and buy a new combination valve and go that route. or maybe cut a hole it the floor and go flintstone style.
thanks for any ideas.