Thanks Bigchief, Well, I do not want to destroy the old one. I plan on reusing it. I was going to cut the section where the pin hole is, then splice it with a rubber fuel hose. The pin hole is located on the 90 degree bend where it wraps around the right side frame of the car. Installing a new line will probably result to the same pin hole due to rubbing of line againist frame of the car. So, If I plan on repairing through splicing, why am I not splicing this rubber hose while it is installed on the car? Because the space I have down there would not allow a tube cutter to rotate. If anyone thinks this is a bad idea, please let me know.