Wouldn't drive 25 miles for most parts, not only a waste of gas but you risk an accident every mile, people are driving nuts with the warmer weather, especially bad are the cell phone talkers and texters.

Rear brakes went great, ran into a snag on the first front brake with a cylinder bolt that refuses to budge. Very inaccessible position, can't get a socket on it due to control arm interference. Wrench will go on but barely, can't get any torque on it. Its 7/16 and is now oversized for the rounded bolt, 11mm almost fits.
Have tried soaking in lube, heating cherry red, needle nose vice grips, haven't turned a thread and it is now all but rounded off.
Broke out the air chisel hoping to snap the head, even that is a failure since the only angle I have I dig more into the backing plate than the bolt. Had to walk away, will try again MON, if necessary I'll chisel the head off by hand, its gotta go.