Hey again, Just was installing my pushrods today, they are going into my 68 350 motor, i put a set of 6x heads off of a later 70's 400, and was installing the pushrods, now i have done this before, not on a real motor(pontiac) though, but when i was tightening down the rocker arm, it seems there is still a fair amount of play in the rocker arm, can anyone send me the procedure on how to properly do this for a pontiac motor? I searched previous posts and have read up a bit about torquing them down to 20ft lbs, and i kept on tightening until i can't anymore and there is still play, would it be safe to say im not using the proper length pushrods?? they are the stock pushrods, and stock rocker arms, but still out of tightening one side of the motor, only two of them could even be tightened down to not chatter. any suggestions or the proper method to installing this? thanks
Ps. you can email me the details or any info to firebird_68@sympatico.ca if it is a long document as i saw in very old posts that people had the method on email or anything like that.. Thanks
