Hey, You could make that pretty easily. It is literally a ring, with one flat side on the inner circle and a couple of small tabs to fold over onto the cable to secure it. A jigsaw, some thin sheet metal a file and a couple of hours. I bet you could even use tin and tin snips.
Get your measurements from the ignitions switch for the ID and go from there.
The end of that fiber-optic cable just points into the hole on the back of the switch.
Last edited by Sleddog; 11/23/1606:59 PM.
Cant wait for summer... 68HO4004spvert Sleddog Iowa
God Bless the men and women past and present that have served this country. Thank you. Support D.A.V. - it helps gives a life back to those who gave so much for us.....
