Comp recommends 988-16 springs for you camshaft. Do you know if that is what's installed now? If not you'll have to check your spring's load force with a spring tester then check height, clearance, bind, etc when they are installed with the new camshaft.
Like Bigchief, I couldn't find the specs on the comp site but Jegs has it:
ID outer-1.060";
id inner-0.804";
seat load 232 pounds at 1.600";
open load 232 pounds at 1.100"
coil bind-1.000";
rate-230 pounds per inch.

You'll have to go to Summit and ask what the recommended springs are for their camshaft and compare them to yours. But as stated above, just because Joe Blow says his springs have specs 'A' don't be surprised if they are not specs 'A'.