Hey guys, or gals- I'm about ready to start prepping my doors & need opinions of how to treat the following...
1. For the inside bottom of door, should I use a POR to incapsulate any rust that may be there or is there another procedure that may work better. 2. Three is a small amount of surface rust on outside bottom, media blast or just sand?
There were two coat of paint on the door, the factory Autumn Bronze & some blue color the previous owner applied. I have sanded the door down as far as I see needed & my plan is to spray a coat of epoxy then filler to flatten then sealer, at a later date install & make final body line contour adjustments if required.
