Thanks for the tip. I checked it out, and the motor mounts are fine - not compressed at all. I found two issues - the crossmember only had 1 bolt in it, so it was shifted a little sideways, and the shifter linkage was bent. It looks like the car was ditched before I got it, and something must have gotten up in there and bent the linkage. The only way that could happen is if it was ditched going in backwards. The previous owner did tell me there was rear end damage on it when he got it. So I installed three more bolts and bent the linkage back some, and it now clears the tunnel. So now I'm dealing with the shifter being too loose to shift properly. When I try for 4th it goes into 2nd. It looks like the 1-2 lever in the shifter is getting dragged along by the 3-4 lever when I go for 4th. Trying to figure out if I can remove the shifter without dropping the tranny to rebuild it...