Thank you, Did you raise the engine then lower it once again after they were installed? Do you think the header flange so close to the floor will transmit heat up into the floor and cabin? How close do you think the pipe is to the steering box, 1/8, 1/4, 3/8,...?
Anyone install the Dougs D ports?
I actually was installing the engine at the same time, but yes I had the engine sitting on the mounts and then raised it back up about two inches placed the headers up on the engine and put a couple header bolts on and then placed the engine back down. I am sure that there will be a little heat transfer to the floor but never had these before so I have no idea how much if any will transmit to the cabin. The third tube back is about 1/8 of an inch away from the steering gear box and the second tube is about 1/2 inch away from the box.
