The housing from the kit does not simply fit the end of our columns, so no.
The bearing housing from the kit is slightly smaller diameter than is the ID of the column tube.
That being said, I think that with a little ingenuity you could adapt it to work.
My first idea would be cutting apart a soda can and use that material to shim the ID of the Column tube
while pressing the kit bearing housing into the column tube.
We are talking about a small diameter mismatch so soda can aluminum may be too thick, dunno it would be close tho.
The bearing kit was $25 amazon prime so at worst its not a huge loss if it doesn't work out.
Hope this helps

Side note: the first bearing kit I ordered came to me with the bearing not freely spinning. I returned it at no cost to me for
a replacement. the second one I received was great, spins freely.