Hell Jim, from the way GM/Delphi are going, you may want to smuggle out as much as you can while the getting is good. Sounds like things aren't going well for anyone there right now. Let's just hope they keep some jobs in this area. I'm the first generation in my family that doesn't work for the Big 3 but everyone's retirement, pension, etc... is all supplied by them.

Anyway, thanks for the comments that have been given. I'm not really looking for someone to fix the bezel for me. My goal is trying to see if I can replicate the missing radio area or possibly even drilled holes, etc. Due to the molding technique that I'm trying to use, I have to do it at room temp and the material has to flow. That leaves polyester or polyurethane. Polyurethane is starting look like the candidate as it shrinks less during the cure. Thanks for the link Jerry, every little bit helps. And as far as business goes, I'd hold off until I can actually make this work. On the positive side, I do have the first set of materials in hand and hopefully can start making the initial casting within the next few weeks.