Thanks again everyone!! I completely see your point on the CG and trying to transport on the rotisserie.. I saw the mounting arm measurments in the earlier pics and was sure glad to see them! I might play with making mount arms that mount to the leaf point using the same measurments.. But at least will mount to the bumper points.
CDJr: I was planning on making adjustable links to mount to the upper door hinge point then back to the latch pin point. I had thought about just welding in a section of square tube in the inside but I thought the NON welding idea would be cleaner. Any other suggestions? I saw pics of one car that had supports welded from the top of the windshield frame to somewhere in the rear by the top boot area. I thought that was a little much but more might be better than less...