When I sanded the drips in the clear I only sanded down level with the clear. You should'nt need to blow any more clear on!?

I just sanded the drip level with 600 (carefully, ie about 3 back and forhts and wipe/check), then 1000, 2000 polish etc.

Perhaps you had extenuating issues tho.

I have a lower door panel (the 3-4 " below the last hard line)that needs a repaint. I intend to mask the line, paint/clear, pull the tape off while the clear is flowing. Then blend the line with 1000 etc. As long as you use a body line of some sort I think it will be OK.

2 days on this side (just fin. last night) This was by far the worst side for drips and sags. Just sanded them out as above, no new clear. All perfect now. Well almost!

This side also has a little of Jims special No. 7 on