guys....you have been great with the help before, but i must once again pick your brains. today while removing the old leaf springs out of my bird, my buddy and i encountered a couple of issues.
1) i got a sway bar set from jegs by Suspension Technologies. cant for te life of me figure out where the ends of the sway bar get bolted on to. is there a place where i can get detailed instructions on how to install this item?
2) the bracket that holds the leaf springs to the car (not the ones that bolt on at the rear of the car, the other ones) are attached to the car by 2 bolts on each side and what appears to be a small weld. there are three bolt holes on this bracket, only two are being used. is this the correct set up? and if so, am i supposed to cut through the weld, mount the new springs and somehow get it re welded to the car?
3) how do you remove the old bushings from where the springs connect at the rear of the car. it looks as though i am purchasing new shackles for the springs. is there a special tool i need to use to get the rear bushings in the spring?

any help will do....your help is always appreciated.