bronze... a "stock" converter usually engages around 1500 rpm. if you want 2600 or more and tci recommends 22-2400 id go with your low end and there high end. 2500 seems a likely number to start with. 2800 may be a bit much unless you have nitrous.
Andy
due to budget cutbacks, the light at the end of the tunnel has been disconnected for non payment.
Believe me, would not have done it if i knew there was loose gravel under the tires. I'll make sure it's clean next time.
Have a 744 hl cam. Work good with your convertor and 3.73's Just need heads, int, and carb. Do you have hedders or stock manifolds? Still have the hedmans out of my old 68. Rusty, but solid. Should clean up fine.
