Done but totally unhappy with it, the fit was as bad as it could ever be, the $40 Ames burlwood is a waste of money. The holes are the wrong size and not exactly where they need to be and overall it was short around the bottom by 1/4" so I'm either gonna try the more expensive $109 one at classic or just give the hydra graphics a shot. If this was jus an unrestored car it would be fine, from 3feet it looks good
Jerry Tallman 69 455/4sp Windward Blue, deluxe parchment bench seat, under major restoration je_tallman@yahoo.com
I realize this is an old post but I am getting ready to do mine, and was going to get the one from Ames. I think Ames has two different ones, which one did you use? I am going to be going to Classic in the next few days to look at theirs. when you did yours did you just remove the thin burlwood layer or did you remove what looks like hard board that is attached to the plastic? what did you use for the radio delete, I want to do that to mine also, and did you redo the chrome trim around the cut outs, if so what did you use there?