The first set of numbers were with 0.014 offset dowels set horizontal, I just had that feeling I got a bad numbers when I did the inital with the stock dowels as I was fighting with the dial indicator and the stand at that time and was using a dial that could only read 0.045 then went and bought a indicator that can read up to an 1" in .001 increments. Way better for the initial runs and then I did my last couple of checks with the more sensitive dial as I knew I have enough travel that it wouldn't run out.

I will be puching the dowels, case, & block as I'm not that interested in repeating this whole procedure, although I am a little better at it now!!!