Is there a easy way to just put a new end on that hose? or should I just buy a new set of hoses?
I can see me not getting a good crimp on a new end for that hoses, so am tempted to just buy a new set, but looks like I would have to replace both side hoses, cause they both share the same end at the side they connect to the electric motor.
I had the same shop that last replaced my convertible top fix these hydraulics so it was strange cause that cylinder in the picture was not bolted to the side of the car correctly, the bolts were sitting in the bottom, and the cylinder was just sitting in there, I have the bolts and they look ok, I don't see why they would have just fallen out, but they look like a pain to get back in place, especialy the back bolt. I hope there is not a problem there, that I am just not seeing yet.
