With the new wheels on I only have about 1/4" thread engagemnet on the nut (they use standard acorn nuts.) Obviously not enough! I'd like to have about 3/4"
After searching several auto parts suppliers, no one seems to make a stud long enough that has the right diameter knurl to fit the axle flanges. Looks like my only options are different wheels (AGAIN) or drill the axles to take a larger knurl stud. (This is for the rear only, I found a suitable replacement for the front discs.)
-=>Lee<=- Due to budget constraints the "light at the end of the tunnel" has been turned off!
