Hi, I have a 68 firebird 350 4spd car now with a 400. The car is stripped down, wiring is out, windows, ect. i have replaced the whole floor, truck pan, rear quarters,tail section and metal dash and some other minor patches. The car was sand blasted on a rotisserie and sealed with a two part epoxy primer. theres no bondo in the car at al its completely sealed. There is a new disc brake set up on the front, all new front end, every bushing is new , all stainless bolts, gas tank is painted, new susp and the list goes on and on.. Well now its time to start putting it back together. Where would you start? The car is NOT painted or finail metal work done, I dont think i will be doing that so i will have to get a friend to do all that. Would you put the wiring harness back in and get the car running again? Right now i dont have the money to pay for paint and body work as i just build a huge shop and im restoring a old 72 gmc i have had since highschool. On the other hand i have most of the parts for the firebird so i can do work on there that wont cost too much. Wheres the best place to start or am i stuck until i want to do paint? any pointers and a direction to go would be great, I have pick up books that will help with the reassembly of the car like "body by fisher service manual, 1968 chassis service manual, and 1968 camaro factory assembly instruction manual" thanks for all your time and knowledge guy!