So as I am putting this 68 back together...I am going thru a lot of head shaking and "what the hell were they thinking" moments
My rear lamp harness was hacked by a previous owner cutting the passenger side marker light connector " along with cutting the terminal off the license plate lamp" and wiring these two together
My questions are what is the two outlet terminal for by the gas filler? "One black-one brown"
Does the license lamp "mind you, the plug was cut off the license lamp" plug into this? Also I have a brown wire in a gromet that is disconnected and assuming that is for the fuel gauge and probably explains why my gauge reads full all the time
Also my trunk floor-quarters-rear wheel wells-tail light pannel were replaced. The previous owner just put the rear harness along the quarter-tail light pannel...Going thru boxes, I found several clips that look as if they secure the wiring Okay...where do the clips go and how do they secure?
