So, I have a couple of very small dents on the RH drip molding. It's something I didn't install myself so I'm wondering how easy it'll be to:

1. remove them. I think you simply take them from the underside and pull them around and up so they release from the drip rail. This is after removing the joint piece near the top of the pillar. I think you can do this just with your fingers?
2. taking out the small dents. I think I could push them out by rubbing lightly from underneath with a small round-ended metal object, resting the top side against a firm surface.
3. re-installing the molding. I think you start from the quarter-window end and work towards the windshield.

Any advice would be appreciated...thanks.