Nice booth. Like the PVC pipe wish I had room for that. When I painted mine it was a lot smaller booth and I used rollers on the body. One bit of advise is if you have a bug landing on it don't panic. Just use a tweezer pull it off and continue clearing. The flow of clear will fill the impression on the paint and the final sand will take care of it. Otherwise the bug will juice and stain the clear. If the base is not vented properly it might turn into dust and sit onto the body. To make sure blow the body off with filtered air Also make sure the top coat of primer is sealed. ( I used a dp primer) Other wise the paint will peal off. If you haven't done it already. This is Major mistake in assuming the primer is going to work well. They require a sealer if it has sat on for a while. Last thing is make sure you buy painters clothing. Tight clothes is a must. Last. Thing is heat causes the air to move and increase dust contamination. Eves or mornings I found is the best.