I wanted to post up the resolution to my squeek squeek squeek.

Whoever guessed the brakes you win! No ware indicator just rivets. Remember only 2300 on the car at this time. The pad where new. I ruined one rotor but replaced both anyway. Below are the EBC red pads that I got. They cost almost around $90 but work as advertised. Less dust and very quiet.

This led into an investigation as to why the pads went bad so quick. I found my booster pin was to long and when I pushed the MC on it would squirt fluid up. Thus it was pre-loading the brakes. There is only suppose to be a .020 gap. I bought a tool from Master power to get the setting right however it was back ordered so I tried using modeling clay. I shaved down the booster pin too much and have a bit of a sponger pedal now. .020 is very thin.

I found out that MP will setup the correct gap for you if you buy the booster and MC together. Also no one sells an adjustable booster pin that I could find, but they do come with Master Power's boosters.