To Gus68, this is my first post on this site so I hope I am doing this right. I recently purchased a fold down rear seat and will be installing is in my '68 when we are finished with the exterior. I have a question about the brackets which the seat hinges hook to which is the same as asked earlier in this thread I quote: Hey Gus, when you install the seat into the car, do the hinges sit flat against the floor brackets or do you have to tighten the nuts to suck it down into place? The aftermarket plates that I just got don't have a deep enough hump for the nub to fit in and allow the hinge to lay all the way down. It didn't come with a stud either so I'll have to work them a bit anyway. You posted some photos to answer the question but they are not accessable. Would you post the photos again if you still have them? Also, I need any measurements of where the brackets go. Any and all help you can give would be greatly appreciated! Thanks in advance.