Switching out a factory auto trans for an era correct 4-speed Muncie m20 (3.08 rear gears). Car is not numbers matching when I acquired her .... but everything is 1st gen on her. Engine is '68 400. She is SCREAMING for a Muncie 4-speed ....
My question I am hoping for guidance on:
When I pull out the brake pedal (automatic) and replace with clutch/brake pedal (manual), can I just pull the clevis pin from existing '67 assembly and switch out the pedals (Ames #FR172 pedal assembly, MT) or do I need to replace the actual pedal carrier assembly also ?
Everything I see is that I pull the pin, replace the pedals, and good to go with hooking up the needed clutch linkage. Seems a bit too easy ?
