I’m installing inner and outer wheel houses and need to get a photo if possible on where the lip goes in relation to the rocker. Keep in mind I have a convertible, does the end of the wheel house contact the rocker at the bottom? Or is there a slight gap for the rain to exit? If so how large a gap should I leave?

I had no reference to begin with as the rear of this bird was large block of bondo and fiberglass.

I’m leaning towards around 1/8 to ¼ inch gap for water exit.
Also while I’m at it, it looks from the other side that the trunk drop off is actually about ½ inch inboard of the wheel house edge? Is this correct?

Bob