Sorry I have been out in the garage finishing up the rear end. The whole system was fine until Dennis and I went to bleed out the fronts after we finished the rear. We are manually bleeding, not vacuum bleeding. Just to recount: We bleed the rears and everything was great. Hard pedal and all. We then figured for good measure that we would bleed the fronts. I pumped up the pedal, Dennis cracked the line (using the right tool, clear line and into a jar filled with fluid so no air could get back in). Went to pump up the brakes again, and it was soft. At this point, we did it over and over with foamy fluid coming out. We then bleed out the MC using the barbs, lines submerged etc... There was NO air in the master at all.
No the car's rear end is jacked up in the air because I am working on the rear end. Will this cause a problem? The delay vale on the switch was not depressed during bleeding at any time.
