Does anyone know how the original stock dual exhaust exited the car? I have some flowmaster tail pipes I got from Summit that are really long, and they exit below the quarter panel roughly a third of the way back from the rear wheelwell to the bumper, then sweep straight back parallel to the ground, where the exhaust shop cut them right below the bumper. I think they are too long. Which way did the original ones point, how far did they come out? Also, I have seen the chrome tail pipe extentions that split into two each side in the Classic Industries catalog. They look as if they would attach where the pipe heads straight back just behind the rear wheel, then would extend down roughly halfway between the rear wheel and bumper and would angle down about 45 degrees. Is this stock? Any help is appreciated.
